Androfill patients have superior functional and aesthetic outcomes in both flaccid and erect states.

Patient A.

The patient had 41 ml of penis filler injected over 3 visits to the Androfill Clinic.

The patient has done an excellent job in moulding this amount of filler for a smooth, natural, result.

The patient’s erect circumference has increased from 5.5 inches to 7.0 inches at the base / 6.75 inches mid-shaft.

An increase of 1.25 – 1.5 inches in circumference (28%) on an already above average length penis.

Some swelling may still be apparent in the first 1 month.

* Individual results may vary from person to person.

Androfill Patient – Before Penis Enlargement – Flaccid

• In the penile enlargement by injection option, the penis is thicker in flaccid and erect states, after one treatment.
• The patient can determine the amount of girth to add, in consultation with the surgeon.
• The amount of girth added depends on the volume of filler added to the penis – generally 8 ml – 20 ml.

Androfill results achieved through injections using both needle and micro-cannula.

To achieve the results below all patients were injected in the flaccid state.

High resolution Before and After photos should be shown in the erect state.

Androfill photos are shown in the erect state which reveals any imperfection in the final result.

Patient B.

10 ml Penis Filler – 0.5-inch increase in erect girth.

Before girth injections: 4.5 inches

After girth injections: 5.0 inch +

* Individual results may vary from person to person.

Before 10ml: Flaccid State.

After 10ml: Flaccid State.

Androfill patient’s photos as posted on Phalloboards Forum

 For a smooth and even result use Androfill ® deep cannula injection technique

Penis filler injected too close to the surface will result in lumpy sub-optimal results.

Androfill results cannot be achieved elsewhere.

Androfill ® is a Registered Trademark

Patient C. 

Injected using 27G needle.

Injected flaccid.

A long patient (7 inches).

8 ml penis filler.

1 cm / 8% increase in thickness along the entire length of the shaft.

Smooth, uniform result after 5 days.

Before 8 ml procedure.

12 cm (4.7 inch) penis girth.

7 inch erect length.

4.5 inch flaccid.

8ml in total used.

After 8 ml procedure.

13 cm (5.1 inch) penis girth (+1 cm entire length)

No change in erect length

5.0 inch in flaccid length (+0.5 inch flaccid length)

Minimal residual bruising – result after 5 days.

A very long penis will require more filler to achieve the same increase in thickness as a shorter penis.

Note the blood vessels above the tape measure, and compare to below with filler.

* Individual results may vary from person to person.

Patient D.

Micro-cannula used.

Injected flaccid.

The patient has customised the final shape of his penis by pressing the filler into place as he prefers, with more filler at the base and end to accentuate the natural upward curve of his penis.

Patients can customise their result like this, to some degree, in the first few days before the filler sets in place.

A Before and After copy of his Clone A Willy – Penis Molding Kit was sent to the clinic providing an exact mould of his penis before 8ml of filler, and 2 months after.

The filler added extra thickness at the right spot to provide extra stimulation to my female companions.

* Individual results may vary from person to person.

Before and After

6 ml Penis Shaft

2 ml Penis Head

Patient’s “Clone A Willy” Moulds

Patient E.

14ml of filler.

27G needle used.

Injected flaccid.

Before Androfill Size:

BPEL 8.2 inch
Mid Girth: 6.0 Inch
Flaccid length: varies from 4.5 – 6.5 Inches
Flaccid girth varies 5.3 inches on average.

Before Androfill Size:

BPEL 8.2 inch
Mid Girth: 6.0 Inch
Flaccid length: varies from 4.5 – 6.5 Inches
Flaccid girth varies 5.3 inches on average.

Back to the hotel – 5 hours after filler procedure.

Minor bruising apparent.

Back to the hotel – 5 hours after filler procedure.

Minor bruising apparent.

Androfill Morning After – Erect

Androfill Morning After – Erect

Patient Testimony from Phalloboards Forum

* Individual results may vary from person to person.

Patient F.

December 2015 – (patient providing multiple updates).

Micro-cannula used.

Injected flaccid.

The patient below had only the lower 2/3 of the penis shaft treated.

The upper portion was left untreated, at the patient’s request.

In total 1.0 inch of additional circumference (thickness) is added to the lower section treated with Androfill (+20% girth).

All patients benefit from increased girth in the flaccid and erect state.

* Individual results may vary from person to person.

Results after 1 session: 8 syringes of filler (8 ml), length part filled.

* Individual results may vary from person to person.

Repeat Treatment, March 2016.

The patient in the above photos subsequently returned for an additional 18 ml of filler to add to the size increase he had already achieved.

The entire length is now filled, and the patient has increased his girth to 7.2 inches in circumference when flaccid.

The after photo below is taken 2 days after the filler treatment.

The patient is displaying more bruising than is typical and swelling may take up to 1 month to subside fully.

The patient’s starting flaccid girth was 5.1 inches, the patient has increased this girth by 40% to over 7.0 inches.

The increase in girth in the photograph above may be accentuated a little by swelling at this early stage.  The patient will provide photographs of his final result in 2-3 months’ time.

In any subsequent enlargement, the filler will likely be placed in the area from the base of the penis to 4/5 of the way down the shaft, to create a slightly tapered result for functional purposes.

It is difficult to increase the girth of the penis to this degree by using the fat transfer method. In a fat transfer, the initial result is impressive, but most of the fat will reabsorb in a few months time.

Untreated After Before

After Penis Enlargement Injections

Swelling and busing are still evident at this early stage.

The reduction of swelling in the first month of the procedure will lessen the result somewhat.

* Individual results may vary from person to person.

Patient F 

– Update, July 2016 – 9 months following the first procedure.

The photos above were taken 2 days following the procedure, with swelling and bruising still evident.

The photos provided by the patient, below, are 8 months after the initial procedure and show the ‘final’ result.  Given the thickness attained, the patient has requested a slightly tapered result from base to glans.  Patients can opt for an even increase in size along the length of the shaft, or some tapering if they prefer.  The head of the penis (glans) can also be enlarged using a thinner filler product.

* Individual results may vary from person to person.

After 30 ml Androfill

After 30 ml Androfill

After 30 ml Androfill

Starting girth: 5.1

After girth: 6.6 / 6.7

Patient G.

Patient from the filming of the Androfill procedure.

Phalloboards Forum member ‘Mischiefmkr’

Micro-cannula and 27G needle used.

Injected flaccid.

Increase from 4.9 inches to 6.6 inches.

Above average length penis.

* Individual results may vary from person to person.

Before Androfill : 5.6-inch girth

After Androfill ( 16ml): 6.6 inch girth.

Patient H.

Directly before, and immediately after, the Androfill penile injection procedure.

Injected flaccid.

27G needle used.

Before 8 ml filler

1 minute after the procedure

1 minute after the procedure.

A number of tiny incisions to heal 1 minute after the procedure.

The injection points will have healed over in a few minutes before the patient leaves the clinic.

Patient I.

Injected flaccid.

27G needle used.

Repeat patient requesting additional filler at the base of the penis, in order to match the increased size achieved by injections to the rest of the shaft.

In the before photo, an indent is visible (this area of the shaft has been under-filled with injections).  In the after photo, more filler has been added so that the base area is slightly wider than the rest of the penile shaft.  The patient will mould the filler to smooth out any irregularities, during the week following the procedure.

In the after photo, a number of small red marks from the injection of filler are still evident. Within 1-2 minutes the incision points will begin to heal and the bleeding will stop well before the patient leaves the clinic.  No stitches are required.

* Individual results may vary from person to person.

Before 16 ml dermal filler to the base of the penis

1 minute after 16 ml to the base

1 minute after the procedure.

A number of tiny incisions to heal 1 minute after the procedure.

The injection points will have healed over in a few minutes before the patient leaves the clinic.

Patient J – Circumcised Patient

Injected flaccid, 27G needle used. A small procedure of 8 ml.

Penis length 6.0 inches erect.

Girth before injections: EG 4.9 – 5.0 inches

Girth after injections: EG 5.5 inches

A 0.5-inch increase in erect girth achieved.

Before 8 ml:

Patient J in Erect State

After 8 ml:

Patient J in Erect State

Before 8 ml:

Patient J in Erect State

After 8 ml:

Patient J in Erect State